NOTE: THIS IS A RE-PUBLISH. UNFORTUNATELY A PLUGIN [AKA “APP”] I DOWNLOADED LAST WEEK HAD MALWARE IN IT SO I HAD TO DO A SITE BACKUP/RESTORE. ALL POSTS & COMMENTS BETWEEN 1/12/2019 & 1/23/2019 WERE LOST.
I am a Federal employee & have been on furlough since 12/22/2018. I’ve been keeping busy with projects and deep cleaning. My 3rd furlough project was replacing the dryer vent in the laundry room. This project wasn’t very exciting, but needed to be done. When I pulled the dryer away from the wall last week I found that the duct tape patch on our old dryer tube had failed and there was lint all over the floor. There was also a clog of half lint/half dryer sheet inside the wall vent. Scary! I cleaned everything up and set about replacing the dryer vent. I had to go to the hardware store for a clamp because we only had one and dryer tubes require two [we’d used duct tape on the old vent but I wanted to do it right this time]. One clamp for the wall vent, and one clamp to attach the tube to the dryer:
Darwin was very happy to assist. He was thrilled that as part of my deep-cleaning project I removed almost everything from the laundry room shelves [I actually removed everything so I could wash the shelves, but he didn’t discover this until I’d started putting things back]:
Replacement tube completed:
After replacing the tube I cleaned the lint from UNDER the lint tray – the lint that gets trapped down below the tray that you never see unless you peak in with a flashlight. I can never get over how much gets trapped down there! I pulled it out with giant tweezers, but you can also use a vent cleaning brush:
Then I washed the rubber ring surrounding our front-loading washer door – SO GROSS:
Darwin was so happy to help me with this entire project:
Stay tuned for furlough project #4!